quick start guide
12 | screenbeam.com
Device Management
Configuring and Managing your new receiver is an important part
of getting the most out of ScreenBeam. There are a number of
security settings, network settings and more that allow you to
configure and optimize ScreenBeam for your specific needs. To
that end, we have provided you two different ways to setup,
configure and manage your ScreenBeam receiver. You can access
the device through a Local Management Interface (LMI) or remotely
setup and manage your device through our Central Management
System (CMS).
Accessing the LMI
There are 3 different ways to connect to the LMI:
Method 1-ScreenBeam Local Wi-Fi Network
1.
Connect the client device’s Wi-Fi to the wireless network (AP
SSID) as shown on the TV display.
2.
Enter the password for the wireless network. screenbeam is the
default password.
3.
The Ready to Connect screen on the display will show the
assigned IP address of the ScreenBeam.
4.
Enter the assigned IP address into the web browser of a PC or
Apple device.
z If the receiver is not connected to an existing wireless network
or LAN, its IP address is 192.168.26.1. z If the receiver is
connected a network, the IP address can be identified on the
Ready to Connect screen.
To Next Page
Loading...
