quick start guide
5.
Wait for the Ready to Connect screen to appear on the display
Optional Connections
6.
If the display has USB HID touch capability, insert the HID USB
connector into a USB port of the ScreenBeam receiver. (USB
cable not included)
7.
If you want to put your ScreenBeam on your local network (not
shown in diagram), connect one end of the Ethernet cable to
the receiver’s Ethernet port and connect the other end to the
network switch with DHCP IP. (Ethernet cable is not included).
Note: Refer to our deployment guide online for more info
on connecting to your network. Note your ScreenBeam
can be connedted to multipe infrastructure networks
simultaneously using both wired and wireless connections.
Complete information is available in the online deployment
guide.
8.
For users that want or require a hard wire connection, connect
an HDMI cable to the HDMI Input port
Your ScreenBeam and Display are now ready for wireless screen
mirroring!
4 | screenbeam.com
To Next Page
Loading...
