35
EN
Channels 4
Frequency 433.92 MHz
Maximum transmitted power < 1mW
Power supply 2 batteries lithium CR2016 included
Security rolling code technology
Remote control
Blinker
Detection Method infrared beam
Sensing Range 10 m max
Input Voltage 12~24V AC/DC
Response Time < 100ms
Operation Indicator RX : Red LED On (beam broken) / Off (beam aligned)
TX : Red LED On
Dimensions 63 x 63 x 30 mm
Output Method relay output
Photocells (option : Ref. AAM0036)
Racks
Racks 12 x 34 cm
Material nylon with steel insert
Bulb 15 LED
Power cable 2 x 1 mm² (not included)
Bulb connection Polarized
Screws included
Power supply 12 V DC
Operating temperature -20°C~+50°C
Dimensions 50 x 70 x 70 mm
Conduct the following operations at least every 6 months. If in high intensity of use,
shorten the period in between.
Disconnect the power supply:
(1) Clean and lubricate the screws, the pins, and the hinge with grease.
(2) Check the fastening points are properly tightened.
(3) Make the wire connection are in good condition.
Connect the power supply:
(1) Check the power adjustments.
(2) Check the function of the manual release.
(3) Check the function of photocells or other safety device.
F- MAINTENANCEF- MAINTENANCE
To Next Page
Loading...
