SDS HotFind-D - Analysis of Temperature Measurement; Recall of Infrared Image

HotFind-D Infrared Camera Operation Manual
13
Note: the noise from the camera when operating is normal.
4.2.2 Analysis of Temperature Measurement
1． After startup the camera, press the “menu(enter)” key to pop up
the menu;
2． Press the direction key（“
△,
+
”、“ ”）to enter the “Analysis”;
3． Press the direction key（“ ”、“ ”）to select “Spot 1”;
4． Press the menu(enter) key again;
5． Move the camera or move the cursor through the direction key to
point to the target;
6． The value displaying on the right-up corner is the target’s
temperature;
7． Multi-spot measurement is available when selecting “Spot 2” and
“Spot 3”.
4.2.3 Store the Infrared image
1. After startup the camera，press the “menu(enter)” key to pop up
the menu;
2. Press the direction key（“
△,
+
”、“ ”）to enter the “File”;
3. Select “Save” and press the “menu(enter)” key;
4. Or you can hold the key “S” for 2-3 seconds to store the image
and the annotation.
4.2.4 Recall the infrared image
1. After startup the camera，press the “menu(enter)” key to pop up
the menu;
2. Press the direction key（“
△,
+
”、“ ”）to enter the “File”;
3. Press the “menu(enter)” key to enter the sub-menu of “File”;
4. Press the direction key（“
△,
+
”、“ ”）to “Open”，select one
infrared image and press “menu(enter)” key;
5. If you can not find the image you want, please press the
direction key（“
△,
+
”、“ ”） till the directory comes out, select the