81
Remove temporary hose and recon-
nect engine water supply hose and
engine water return hose.
Remove hose pincher.
All Models
The following steps should be per-
formed to provide the watercraft en-
hanced protection.
Remove muffler and drain out as
much water as possible. Reinstall
muffler.
OR: Disconnect one hose from muf-
fler and pour some antifreeze solution
inside muffler. Reconnect hose.
Lubricate the throttle cable with BOM-
BARDIER LUBE lubricant.
NOTE: A cable luber can be used
on throttle cable end to inject
BOMBARDIER LUBE lubricant.
Clean the bilge with hot water and de-
tergent or with bilge cleaner. Rinse
thoroughly. Lift front end of watercraft
to completely drain bilge. If any repairs
are needed to body or to the hull con-
tact your dealer. For paint touch up to
mechanical parts use Bombardier
spray paint. For small gelcoat repairs,
a Bombardier repair kit is available.
See ACCESSORIES AND SERVICE
PRODUCTS section. Replace dam-
aged labels/decals.
NOTE: Bilge cleaning should be
done prior to anticorrosion treat-
ment.
Wash the body with soap and water
solution (only use mild detergent).
Rinse thoroughly with fresh water. Re-
move marine organisms from the hull.
Apply a nonabrasive wax such as sili-
cone wax.
If the watercraft is to be stored out-
side, cover it with an opaque tarpaulin
to prevent sun rays and grime from af-
fecting the plastic components, wa-
tercraft finish as well as preventing
dust accumulation.
The seat should be partially left
opened during storage (except
HX/XP). This will avoid engine com-
partment condensation and possible
corrosion.
NOTE: If the watercraft is stored
outside with seat partially opened
and without a tarpaulin, unscrew the
rear drain plug in order to avoid water
build up in the bilge during rainfall. Tilt
the watercraft to the rear so that wa-
ter can flow out of floorboard.
Pre-Season Preparation
Use the following chart.
Since technical skills and special tools
are required, some operations should
be performed by an authorized dealer.
-
CAUTION
Never clean apparent fiberglass
and plastic parts with strong de-
tergent, degreasing agent, paint
thinner, acetone, etc.
'
'
-
CAUTION
The watercraft must never be left
in water for storage. Never leave
the watercraft stored in direct
sunlight. UV rays will dull finishes.
◆
WARNING
Observe all WARNINGS and
CAUTIONS mentioned through-
out this guide which are pertinent
to the item being checked. When
component conditions seem less
than satisfactory, replace with
genuine BOMBARDIER parts or
approved equivalents.
smo9701a.bk : smo9701b.fm5 Page 81 Monday, November 3, 1997 9:54 AM
To Next Page
Loading...
Need help?
General