SeaDoo XP DI - General; Removal

Section 13 PROPULSION
Subsection 02 (DRIVE SYSTEM)
GENERAL
Jet pump must be removed to replace any com-
ponents of the drive system. Refer to JET PUMP
for removal procedure.
REMOVAL
PTO Flywheel Guard
GTI Series
Remove seat(s).
Remove vent tube support or seat support.
Remove plastic wing nuts retaining PTO flywheel
guard no. 1 to engine support.
Detach PTO flywheel guard from engine and with-
draw from bilge.
XP DI Models
Open engine compartment cover.
Remove storage basket.
Remove vent tubes from PTO flywheel guard.
Remove PTO flywheel guard.
Large Clamp
GTI Series
Unfasten large clamp of PTO flywheel boot no. 3
as follows:
– Use pliers (P/N 295 000 069).
F01J0GA
– Insert pointed tips of pliers in closing hooks.
1
F01J2AA
TYPICAL
1. Closing hooks
– Squeeze pliers to draw hooks together and dis-
engage windows from locking hooks.
1
F01J29A
TYPICAL
1. Locking hooks
Small Clamp
GTI Series
Unfasten small clamp of PTO flywheel boot as fol-
lows:
– Use pliers (P/N 295 000 054).
656 smr2004-Complete Line Up
www.SeaDooManuals.net