Seaga INF4C - General Cautions and Safety Guidelines

9Revision 2.EL950 1.3.1074C 18.6
CAUTIONS
Your vendor is intended for indoor use only.
Excessive heat, cold or humidity levels will void your warranty; install only in climate
controlled, indoor environments. For indoor machines the temperature range must be
no higher than 32°C/90°F and no lower than 10°C/50°F with a relave humidity (Rh)
level of no greater than 40%.
Your vendor must be set on a level, well-supported locaon. Always unload vendor
before transporng it.
Remove all wire es and protecve sheeng prior to vending.
CAUTION
It is important that this machine is hooked up to the proper voltage. Verify the voltage
before connecng the machine to a wall outlet.
CAUTION
Dierent countries may have dierent power arrangements. Insure that the machine is
properly grounded before operang.
CAUTION
If the power cord is damaged, it must be replaced by the manufacturer, authorized ser-
vice agent or a similarly qualied person to avoid electrical hazards.
ATTENTION
This vending machine is very heavy. Ensure that sucient personnel are available for
liing or transporng the machine. Use proper liing procedures and equipment.
CAUTION
Certain components of this machine are sensive to stac electricity. Precauons for
handling sensive devices should be observed when handling these items.
ATTENTION
Refrigerated models need air ow. Leave at least 6” between the back of the vending
machine and the wall. Condenser cooling air is taken in the boom and exhausted out
the back of the machine. Clean the condenser once every two weeks or more oen for
dusty or dirty locaons.