7
1.
4.
5.
6.
7.
2.
3.
INSTALLING THE ALLERON SERVOS
Because the size of servos dier,
you may need to adjust the size of the
precut opening in the mount. e notch
in the sides of the mount allow the servo
lead to pass through.
Place the servo between the mounting
blocks and space it from the hatch. Use a
pencil to mark the mounting hole loca-
tions on the blocks.
Use drill bit in a pin vise to drill the
mouting holes in the blocks.
Apply 2-3 drops of thin C/A to each
of the mounting holes. Allow the C/A to
cure without using accelerator.
Use dental oss to secure the connec-
tion so they cannot become unplugged.
Secure the servo to the aileron hatch
using Phillips screwdriver and the screws
provided with the servo.
C/A glue
Minimum servo spec.
Torque : 194 oz-in (14 kg-cm) @ 6.0V;
236 oz-in ( 17kg-cm) @ 7.4V
To Next Page
Loading...
