10. TROUBLESHOOTING
This tool may cause Hand Arm Vibration Syndrome if its use is not managed adequately.
This tool is subject to the vibration testing section of the Machinery Directive 2006/42/EC.
This tool is to be operated in accordance with these instructions.
Measured vibration emission value (a): .........0.494m/s²
Uncertainty value (k):...........................1.5m/s²
Please note that the application of the tool to a sole specialist task may produce a different average vibration emission. We recommend that a
specific evaluation of the vibration emission is conducted prior to commencing with a specialist task.
A health and safety assessment by the user (or employer) will need to be carried out to determine the suitable duration of use for each tool.
NB: Stated Vibration Emission values are type-test values and are intended to be typical.
Whilst in use, the actual value will vary considerably from and depend on many factors.
Such factors include; the operator, the task and the inserted tool or consumable.
NB: ensure that the length of leader hoses is sufficient to allow unrestricted use, as this also helps to reduce vibration.
The state of maintenance of the tool itself is also an important factor, a poorly maintained tool will also increase the risk of Hand Arm Vibration
Syndrome.
Health surveillance.
We recommend a programme of health surveillance to detect early symptoms of vibration injury so that management procedures can be
modified accordingly.
Personal protective equipment.
We are not aware of any personal protective equipment (PPE) that provides protection against vibration injury that may result from the
uncontrolled use of this tool. We recommend a sufficient supply of clothing (including gloves) to enable the operator to remain warm and dry
and maintain good blood circulation in fingers etc. Please note that the most effective protection is prevention, please refer to the Correct Use
and Maintenance section in these instructions. Guidance relating to the management of hand arm vibration can be found on the HSC website
www.hse.gov.uk - Hand-Arm Vibration at Work.
PROBLEM POSSIBLE CAUSE SOLUTION
Motor (pump) will not work Switch set at
OFF
The switch is set to OFF Set switch to ON
Switch set at
ON
No battery charge Recharge the battery cartridge. Replace the
battery if recharging is ineffective
Wiring connector is disconnected Repair at authorised Sealey service centre
Wiring break Repair at authorised Sealey service centre
ON-OFF switch broken Repair at authorised Sealey service centre
Motor (pump) not working Repair at authorised Sealey service centre
Blown fuse Repair at authorised Sealey service centre
Pump is working but no spray is coming
out
Blocked nozzle Clean or replace
Chemical tank is empty Refill with required liquid
Blocked vent hole on tank lid Clean
Blocked piping Repair at authorised Sealey service centre
Broken or cracked piping Repair at authorised Sealey service centre
Disconnected or broken piping Repair at authorised Sealey service centre
Blocked water absorption strainer Remove and clean
Spraying pressure is low Blocked vent hole on tank lid Clean
Blocked piping Repair at authorised Sealey service centre
Broken or cracked piping Repair at authorised Sealey service centre
Disconnected or broken piping Repair at authorised Sealey service centre
Blocked water absorption strainer Remove and clean
Blocked control handle strainer Remove and clean
Abnormal pressure regulator Repair at authorised Sealey service centre
Worn gear case Repair at authorised Sealey service centre
Abnormal sound when sprayer is switched
ON
Broken pump drive coupling Repair at authorised Sealey service centre
Blocked nozzle Clean or replace
Sprayer is switched OFF but a large
volume of liquid escapes from nozzle
Trigger lever is at locked on position Set trigger lever to the OFF position
CP20VGBS Issue 1 29/11/21
Original Language Version
© Jack Sealey Limited
To Next Page
Loading...
