EasyManua.ls Logo

Sealey G3500I - Engine Corrosion Protection

Sealey G3500I
8 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 sales@sealey.co.uk www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product
becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and
dispose of the product and fluids according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
9.1.8. Let the generator cool down.
9.1.9. Remove the screws, and then remove the cover.
9.1.10. Drainthefuelfromthecarburettorbylooseningthedrainscrewonthecarburettoroatchamber.
9.1.11. Tighten the drain screw.
9.1.12. Install the cover and tighten the screws.
9.2. ENGINE
9.2.1. Perform the following steps to protect the cylinder, piston ring, etc. from corrosion:
9.2.2. Removethesparkplug,pourabout18mlofSAE15W-40intothesparkplugholeandreinstallthesparkplug.Recoilstarttheengine
by turning over several times (with 3 in 1 switch knob off) to coat the cylinder walls with oil.
9.2.3. Pull the recoil starter until you feel compression. Then stop pulling. (This prevents the cylinder and valves from rusting).
9.2.4. Clean exterior of the generator. Store the generator in a dry, well-ventilated place, with a the cover placed over it.
Original Language Version
© Jack Sealey Limited
G3500I Issue 1 10/02/23
REGISTER YOUR
PURCHASE HERE

Related product manuals