SealMaster SP 300 - Filling Material Tank

11
SQUEEGEE SP300
FILLING MATERIAL TANK:
9. When cutting material in the machine, always place sealer in the
tank before adding water.
10. Start the agitator by moving the agitator control valve #H-10
to the forward position. Agitate speed with control speed knob
on agitator motor #H-9. Set agitator to a proper consistent
speed.
11. To avoid a buildup of sand on the sides of the machine,
always pour sand into the center of the tank. The usual amount
of sand used to provide an anti-skid surface or to fill porous
pavement is three pounds per gallon of sealer. This will vary
according to the porosity of the surface you are sealing.
42 CONTROL
LEVER
H-10 AGITATOR
CONTROL VALVE
7 WATER TOGGLE
SWITCH
H-14 REAR ASSEMBLY
UP AND DOWN
H-15 REAR ASSEMBLY
LEFT AND RIGHT
33 CHOKE
34 THROTTLE
1 IGNITION SWITCH