27
OPERATION INSTRUCTION SP300 DUAL/SPRAY
BEFORE STARTING ENGINE:
17. Follow the maintenance procedures listed in the engine
manual.
18. Check the gas supply.
19. Make sure the control lever #1, located at the left of the
steering wheel, is in the neutral position. Along with the 3 levers
#7 #8 #9 to the right of the steering wheel.
TO START ENGINE:
20. Position yourself in the operator’s seat.
21. COLD ENGINE: Turn key to RUN on control panel-engine
display #74, located on the control panel. Let the display go into
its cycle, then turn key to CRANK. Allow the engine to warm up
before operating.
TO OPERATE MACHINE:
22. To move the machine forward, push control lever #1
forward SLOWLY until your desired speed is reached.
To move the machine in reverse, pull the control lever to neutral,
completely stopping before going into the reverse position.
NOTE: Always STOP completely, before changing directions.
NEVER operate the machine in reverse, with Rear Assembly in the
DOWN position.
To Next Page
Loading...