Searey LSA - 4.1.3 Preflight Inspection Area 3 - Engine; 4.1.4 Preflight Inspection Area 4 - Empennage

Searey LSA – Pilot’s Operating Handbook Version 5.0, Revision 8
24
4
Wing Float, Braces & Secure Attachment
CHECK
5
Aileron Outer Push-Pull Rod Attachment
(Jam locknuts secure)
SECURE
6
Aileron Movement and Hinges
FREE
7
Flap & Push-Pull Attachment and Hinges
SECURE
8
Wing to Aft Fuselage Brace Cable
SECURE
9
Wing Tie-Down (if applicable)
REMOVE
4.1.3 PREFLIGHT INSPECTION AREA 3 - ENGINE
1
With MAGS OFF! Rotate prop counter
Clockwise minimum 2 full turns to circulate oil
CHECK
2
Engine Cowling Doors (if applicable)
OPEN
3
Engine Cowling Secure to Aircraft (if applicable)
CHECK
4
Oil Level and Oil Line attachments, condition
CHECK
5
Coolant Level and Hose Attachments
CHECK
6
Exhaust retaining Springs
CHECK
7
Propeller – Nicks, Cracks & Security
CHECK
8
Carburetor Attachment & Induction System
SECURE
9
All Pipes & Hoses – Leakage, Wear & Security
CHECK
10
Exhaust & Muffler Springs, Cracks, Attachment
CHECK
11
Coolant Level & Color
CHECK
12
Engine Mounts Condition & Secure
CHECK
13
Electrical Cables – Wear & Secure
CHECK
14
Engine Cowling Doors Closed (Camlocs)
SECURE
15
Forward Hull Drain Plug
CHECK
4.1.4 PREFLIGHT INSPECTION AREA 4 – EMPENNAGE
1
Stabilizer Leading Edge Trim Attachment
CHECK
2
Elevator Push-Pull Tubes & Horn Attachment
CHECK
3
Upper & Lower Tail Cables, Turn Buckle Lock
CHECK
4
Elevators & Rudder – Free Movement, Security
SECURE
5
Tail Wheel for Inflation & Wear
CHECK
6
Tail Tie-Down
REMOVE
7
Aft Hull Drain Plug
CHECK