Searey LSA - Section 9 - Supplements; 9.1 Continued Airworthiness Maintenance Program; Engine; Engine Mounting

Searey LSA – Pilot’s Operating Handbook Version 5.0, Revision 8
72
Section 9 – Supplements
9.1 CONTINUED AIRWORTHINESS MAINTENANCE PROGRAM
Perform the following every 100 hours or annually, whichever comes first,
unless noted otherwise:
ENGINE
 Refer to and follow your engine manufacturer’s manual for maintenance
procedures on engine.
ENGINE MOUNTING
 Inspect engine mounting parts, hardware and bolts for condition (wear,
distortion, cracks, etc.) and security.
 Check engine mount bolts and nuts for security.
 Inspect rubber engine mounts for condition (deterioration, distortion, cracking,
etc.). Replace if necessary.
LUBRICATION
 Drain engine oil and replace with fresh oil (every 50 hours with Mo Gas, 25 hours
with Avgas)
 Check engine drain plug and oil sump plug for metal particles.
 Replace oil filter each time oil is changed.
CARBURETION AND AIR INTAKE SYSTEM
 Clean and re-oil or replace air filters.
 Check carburetors for proper position and security.
 Check throttle linkage for condition and operation.
 Remove and clean float bowls.
 Check for carburetor synchronization.
EXHAUST SYSTEM
 Check exhaust system for cracks, leaks and security (every preflight). Replace
manifold gasket if necessary.
 Check mounting hardware and springs for condition (cracks, wear, spring
fatigue) and security (every preflight).
 Apply a bead of silicone rubber on springs to extend spring life.
 Lubricate exhaust joints with high temperature anti-seize compound.
 Check for adequate clearance from other parts, hoses, wires, etc.
PROPELLER
 Check propeller blades and hub for nicks, splits, cracks, excessive wear or other
damage.