Sears GT Series User Manual

APPLICATION CONSIDERATIONS
Geothermal Systems
Closed loop and pond @plications require specialized design
knowledge. No attempt at these installations should be made unless
the dealer has received specialized training. Anti-freeze solutions
are utilized when low evaporating conditions are expected to occur.
Refer to the Flow Center installation manuals for more specific
instructions. (See Fig. 2)
i0
F Diagram shows typical q
I installation and is for I
I illustration purposes I
I only. Ensure access to I
I Heat Pump is not I
restricted.
I I
L. /
(1) Line Voltage Disconnect (unit)
(2) Flex Duct Connection
(3) Low Voltage Control Connection
(4) Line Voltage Connection
(5) P/T Ports
(6) Vibration Pad
(7) Condensate Drain Connection
(8) Ground Loop Connection Kit
(9) Ground Loop Pumping Package
(10) Polyethylene with Insulation
(11) Line Voltage Disconnect (electric heater)
Fig. 2 - Example Geothermal System Setup
A14132

Sears GT Series Specifications

General

Heating Capacity	Varies by model, typically between 18, 000 BTU/h and 60, 000 BTU/h
Cooling Capacity	Varies by model, typically between 18, 000 BTU/h and 60, 000 BTU/h
SEER Rating	Varies by model, typically between 13 and 16
HSPF Rating	Varies by model, typically between 7.0 and 8.5
Stages	Single-stage or Two-stage (depending on the specific model)
Refrigerant	R-22 or R-410A (depending on the specific model and year of manufacture)
Warranty	Varies, typically 1-year parts and labor, 5-year compressor (check specific model details)