Need help?Do you have a question about the SeaSTAR 3510LR and is the answer not in the manual?
General| Dimensions | 2.0" x 2.0" x 0.4" |
|---|---|
| Weight | < 1.0 ounce |
| Input Impedance | 50 ohms |
| Input Voltage | +5.0 VDC |
| Power Supply | +5.0 VDC |
This manual has been produced to assist the typical user with the installation and operation of the 3510LR DGPS Receiver.
The 3510LR DGPS Receiver is a component part of the Fugro world-wide DGPS Service, delivering corrections from an array of GPS reference stations.
This section guides users on getting started with the 3510LR, covering satellite data carrier reception and checking the GPS engine.
Details how to set up the 3510LR receiver for RTCM mode, including data port configuration for GPS receiver compatibility.
Explains how to connect the power supply to the 3510LR, including voltage requirements, power consumption, and connector pinout.
Provides guidance on determining the best location for the 3510LR in a vehicle or aircraft, considering various environmental factors.
Details the requirement for a perfect vehicle chassis ground connection for the 3510LR receiver.
Illustrates the primary menu structure of the 3510LR receiver as it appears immediately after powering on.
Provides essential guidelines for the proper care, charging, and maintenance of portable batteries used with the receiver.
Outlines the steps to follow when an OmniSTAR receiver unit fails to perform, including contacting the Network Control Centre.
Details how to open and use the OmniSTAR Receiver Toolkit software for configuring and managing the receiver.
Provides a form to copy and fill out for reporting problems with the OmniSTAR receiver, including detailed descriptions.
To Next Page
