Need help?Do you have a question about the SeaSTAR 3610 and is the answer not in the manual?
Describes the manual's organization into chapters and appendices.
Details the Fugro DGNSS Service, its features, and the receiver's system components.
Guides the user through initial setup, including power, antenna, and basic configuration.
Configures the receiver for DGNSS, HP/XP/G2, or VBS modes, detailing necessary settings.
Details power requirements, consumption, connector pin layout, and antenna connection.
Explains serial port pin layouts, data cable configurations, and UDP port settings.
Explains display, keypad, LEDs, menu navigation, and alarm situations.
Lists and briefly describes key menu pages like Signal Status, About, and Status.
Configures position, channels, ports (Serial, UDP, TCP/IP, FTP).
Selects GPS/GLONASS sites and configures display/backup settings.
Covers installation factors, antenna location, and cable routing guidelines.
Shows status details for channels A and B, including service, frequency, and lock status.
Displays the status of NTRIP connection and VBS input data.
Displays current and previous alarm situations, including timestamps and error codes.
Shows position input, GPS time, and antenna power status.
Shows which ports are configured for different correction formats.
Allows channel selection and sets satellite service, frequency, and symbol rate.
Configures NTRIP settings, including enable/disable, server address, username, and password.
Allows manual input of position coordinates and controls antenna power.
Configures serial port settings like baud rate and service enable/disable for ports A and B.
Configures UDP, TCP/IP, and FTP port settings.
Selects the nearest GPS L1 reference sites or manual site selection.
Selects the nearest GLONASS L1 reference sites or manual site selection.
Configures display backlight on/off and contrast levels.
Saves the current receiver configuration and allows restoration.
Displays diagnostic information about the receiver's firmware versions and build dates.
Shows diagnostic status details, including lock status, restarts, and counts.
Allows configuration of various diagnostic parameters, such as serial port setup and debug modes.
Displays diagnostic information related to GPS, GLO, IONO, and VBS correction data reception.
Provides input/output statistics for various data types, showing reception and transmission counts.
Resets the diagnostic statistics counters to zero.
Allows erasing of the receiver's flash memory, including main and IO images.
Recalibrates the Digital-to-Analog Converter (DAC) for improved performance.
To Next Page
General