SeaSTAR 3610 - Display Configuration Menu; Backup Configuration

SeaSTAR 3610 USER MANUAL
Issue 2.3 02/11
19
The following options may be selected:
On/off/nearest
It is possible to set all GLO L1 sites on or off, or only to use the
nearest stations. How many of the nearest stations to use, is
configurable. Factory default value is 32. When using the nearest
sites option, it is important to insert the position into the receiver.
The position is set in the Set Pos/Ch menu, or through port A or B
as a GGA message.
Set GLO L1 Site
Site Nearest
When setting all GLO L1 sites on or off, it is possible to manually
set which sites to use or not use. The reference station sites are all
received on the air and stored in the receiver.
Use the  and  buttons to view the available reference stations.
Press the  button to be able to change the setting. Use the  and
 buttons to select the setting and press  to save the setting.
Set GLO L1 Site
Use 32
Set GLO L1 Site
Site 132 On
Display configuration menu
From the Display Cfg menu it is possible to change contrast and
enable or disable backlight on the display.
Main Menu
Display Cfg
The Backlight On menu simply switches the display backlight on
or off.
The Contrast menu has three choices for the display contrast:
High
Medium
Low
Display Cfg
Backlight On
Display Cfg
Contrast High
Backup configuration
The Backup Cfg menu makes it possible to store the current configuration for port
settings and corrections settings, with the Save submenu. If lost, the stored
configuration can then be easily restored by selecting the Restore submenu.
Main Menu
Backup Cfg
Backup Cfg
Save
Restore Cfg
Restore
Note! Restore is only possible if user configurations have been
previously saved. It will also reset the receiver.
1005600PMA0