256 If and when
Towline anchorages
Fig. 210 The front right
section of the vehicle:
Fitting the front towline
anchorage
Fig. 211 Fitting the tow-
line anchorage to the rear
of the vehicle.
Front towing eye
– Take the towline anchorage from the on-board tool set.
– Remove the cover by pressing down on its left-hand side.
– Bolt the anchorage to its limit to the left, in the direction of the
arrow ⇒ Fig. 210.
Rear towline anchorage
– Take the towline anchorage from the on-board tool set.
– Remove the cover by pressing down on its right-hand side.
– Bolt the anchorage to its limit to the left, in the direction of the
arrow ⇒ Fig. 211.
After use, unscrew the towline anchorage and put it back in the vehicle tool
kit. Replace the cover on the bumper. The towline anchorage should always
be kept in the vehicle.
To Next Page
Loading...
