Seat Ateca 2016 - Page 137

Lights and visibility
●
When the c
ar door i
s opened, the “Coming
Home” lighting comes on. The headlights are
turned off 60 seconds after the vehicle door
is opened.
Deactivation
●
If no door has been closed, they go out au-
tomatically after 60 seconds.
●
After the last door has been closed, the
headlights will be switched off after the
“Coming Home” delay (as established in the
radio menu) has elapsed.
●
On turning the light switch to position 
›››

page 23.
●
When the ignition is switched on (when
starting the engine).
Function “Leaving Home”
The “Leaving Home” function is only availa-
b
l
e for vehicles with a light and rain sensor
(rotary light switch in position ).
This function may be connected/disconnec-
ted through the radio menu. The “Leaving
Home” function switch-off delay may also be
set (default: 30 sec).
Vehicle with halogen headlights
In the “Leaving Home” function, the daytime
running lights (DRL), the rear side lights and
the licence plate lights are switched on.
Vehicle with full-LED headlights
In the “Leaving Home” function, the dipped
beams, the daytime running lights (DRL), the
rear side lights and the registration plate
lights switch on (“Welcome Light”).
Activation
●
When the vehicle is unlocked using the re-
mote control.
●
The “Leaving Home” function is only activa-
ted when the rotary light switch is in position
 and the light sensor detects darkness.
Deactivation
●
When the “Leaving Home” delay period
ends (default: 30 sec).
●
When the vehicle is locked using the re-
mote control.
●
When the light control is switched into a
position other than .
●
With the ignition is switched on.
Hazard warning lights 
Fig. 135 Dash panel: switch for hazard warn-
in
g lights.
Read the additional information carefully
›
›
›

page 24
The hazard warning lights are used to draw
the attention of other road users to your vehi-
cle in emergencies.
If your vehicle breaks down:
1. Park your vehicle at a safe distance from
moving traffic.
2. Press the button to switch on the hazard
warning lights ›››
.
3. Switch the ignition off.
4. Apply the handbrake.
5. For a manual gearbox, engage 1st gear;
f
or an aut
omatic gearbox, move the gear
lever to P.
»
135
Technical dataAdviceOperationEmergenciesSafety