EasyManua.ls Logo

Seat Ateca 2016 - Seat Functions

Seat Ateca 2016
328 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operation
Adjusting the head restraints
To set the head restraint higher, grasp the
s
ide
s with both hands and move it up-
wards, until you see it engage.
To set the head restraint lower down, press
the
1
Fig. 141
button and move it
downwards.
Removing the head restraint
To remove the head restraint, the correspond-
ing backrest must be partially folded forward.
Unlock the backrest page 146.
Move the head restraint upwards until it ar-
rives to the top.
Press button
1
Fig. 141, while simulta-
neously pressing on the security hole
2
Fig. 141 with a fl
at screwdriver a maxi-
mum of 5 mm wide, and remove the head
restraint.
Move the backrest until it engages properly
.
Fittin
g the he
ad restraint
To mount the external head restraints, the
corresponding backrest must be partially fol-
ded forward.
Unlock the backrest page 146.
Insert the head restraint bars into the
guides until they perceptibly engage. It
should not be possible to remove the head
restraint from the backrest.
Move the backrest until it engages properly
.
WARNING
Ple
ase observe the general notes
page 66.
Remove the rear head restraints only when
it is necessary for the placement of a child
seat page 79. After removing a child seat,
remount the head restraint immediately.
Travelling with the head restraints removed
or improperly adjusted increases the risk of
severe injuries.
Seat functions
Intr
oduction
WARNING
Inappropriate use of the seat functions can
cau
se severe injuries.
Assume the proper sitting position before
your trip and remain in it throughout. This al-
so applies to the other occupants.
Always keep hands, fingers, feet and other
parts of the body away from the operating ra-
dius and the adjustment of seats.
Seat heating
Fig. 142 In the centre console: front seats
he
atin
g switch
The seat cushions can be heated electrically
when the ignition i
s
switched on. The back-
rest is also heated in some versions.
The seat heating should not be engaged in
any of the following conditions:
The seat is unoccupied.
The seat has a covering.
There is a child seat installed in the seat.
The seat cushion is wet or damp.
The indoor or outdoor temperature is great-
er than 25°C (77°F).
Activate
Press the button or . Seat heating is
switched on fully.
144

Table of Contents

Related product manuals