Seat Ateca 2016 - Page 39

The essentials
Operation of the turn signal lever
●
Switching on the CCS: Move switch
›
›
› Fig. 47
1
to .
The system is on. If no
s
peed has been programmed, the system will
not control it.
●
Activating the CCS: Press button ››› Fig. 47
2
in the  ar
e
a. The current speed is
memorised and controlled.
●
Temporarily switching off the CCS: Move
switch ››› Fig. 47
1
to 
 or push the
br
ake. The cruise control system is switched
off temporarily.
●
Reactivating the CCS: Press button
››› Fig. 47
2
in 

. The memorised speed
is saved and controlled again.
●
Increasing stored speed during CCS regula-
tion: press button
2
in 

. The vehicle ac-
celerates until the new stored speed.
●
Reducing stored speed during CCS regula-
tion: press button
2
in  t
o lower the
s
peed by 1 km/h (1 mph). Speed is reduced
until reaching the new stored speed.
●
Switching off the CCS: Move switch
››› Fig. 47
1
to .
The system is disconnec-
t
ed and the memorised speed is deleted.
Operation using the third lever
●
Switching on the CCS: move the third lever
to  ››› Fig. 48. The system switches on but it
does not control the speed as no speed has
been programmed.
●
Activating the CCS: press the  ››› Fig. 48
button. It memorises and maintains the cur-
rent speed.
●
Temporarily switching off the CCS: move
the lever to  ››› Fig. 48 and release it or
press the brake pedal. The cruise control sys-
tem is switched off temporarily.
●
Reactivating the CCS: move the lever to
 ››› Fig. 48 and release it. The memo-
rised speed is saved and controlled again.
●
Switching off the CCS: move the third lever
to position  ››› Fig. 48. The system is dis-
connected and the memorised speed is de-
leted.

››› in Operation on page 193

››› page 193
37