EasyManua.ls Logo

Seat Ateca 2016 - Page 55

Seat Ateca 2016
328 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The essentials
Repairing a tyre with the anti-punc-
t
ur
e kit
Fig. 67 Standard representation: contents of
the anti-p
u
ncture kit.
The anti-puncture kit is located under the
floor p
anel
in the luggage compartment.
Sealing the tyre
●
Unscrew the tyre valve cap and insert. Use
the ››› Fig. 67
1
tool to remove the insert.
Pl
ac
e it on a clean surface.
●
Shake the tyre sealant bottle vigorously
››› Fig. 67
10
.
●
Screw the inflator tube ›
›
› Fig. 67
3
into
the se
al
ant bottle. The bottle's seal will break
automatically.
●
Remove the lid from the filling tube
››› Fig. 67
3
and screw the open end of the
t
ube int
o the tyre valve.
●
With the tyre sealant bottle upside down,
fill the tyre with the contents of the sealant
bottle.
●
Remove the bottle from the valve.
●
Place the insert back into the tyre valve us-
ing the tool ››› Fig. 67
1
.
Infl
atin
g the tyre
●
Screw the compressor tyre inflator tube
››› Fig. 67
5
into the tyre valve.
●
Check that the air bleed screw is closed
›
›
› Fig. 67
7
.
●
Start the engine and leave it running.
●
Insert the connector ›
›
› Fig. 67
9
into the
v
ehic
le's 12-volt socket ›››
page 148.
●
Turn the air compressor on with the ON/OFF
switch ››› Fig. 67
8
.
●
Keep the air compressor running until it
r
e
aches 2.0 to 2.5 bar
(29-36 psi/200-250 kPa). a maximum of 8
minutes.
●
Disconnect the air compressor.
●
If it does not reach the pressure indicated,
unscrew the tyre inflator tube from the valve.
●
Move the vehicle 10m so that the sealant is
dis
tributed throughout the tyre.
●
Scr
ew the compressor tyre inflator into the
valve.
●
Repeat the inflation process.
●
If the indicated pressure still cannot be
reached, the tyre is too badly damaged. Stop
and request assistance from an authorised
technician.
●
Disconnect the air compressor. Unscrew
the tyre inflator tube from the tyre valve.
●
When the tyre pressure is between 2.5 and
2.0 bars, continue driving without exceeding
80 km/h (50 mph).
●
Check the pressure again after 10 minutes
›››
page 85.
››› in TMS (Tyre Mobility System)* on
page 83
››› page 83
53

Table of Contents