PAC3760 plus
Operating Instructions
9
If the measured value is greater than the 1 ohm pass/fail
threshold, the measured value is displayed and the unit
indicates a fail result as shown below.
If the measured value is less than or equal to the 1 ohm
pass/fail threshold, the measured value is displayed and
the unit indicates a pass result, as shown below.
If the Earth Continuity test has passed then the unit will
proceed with an Insulation test.
Note: The power switch on the appliance under test
must be in the ON position to perform an
insulation test. If no appliance is detected the
PAC3760 plus will display LO LOAD.
If the LO LOAd enunciator is displayed, the load
presented by the appliance may be too small for the
PAC3760 plus to detect. In this case, press the Class I test
button to continue.
To Next Page
