Required radio, motor and battery
Radio equipment:
• Minimum 5-channel radio system
• 4 standard or low profile digital servos with metal gear (JR PROPO DS 9511)
• 2 servo extension 300mm, for elevator and rudder servos
• 2 servo extension 100mm, for aileron servos
Recommended electric motor for best performance:
• Hacker A50-16S + ESC 70A SBEC + APC 16 x 12E or 17 x 8E
Recommended Li-Po battery pack for best performance:
• 3900-6S Thunder Power for unlimited 3D performances
Additional required item, tools and adhesives
Tools:
• Drill
• Drill bits: 1,5mm
• Flat blade screwdriver
• Phillips screwdriver large and small
• Hobby knife
• Masking tape
• Soldering iron
• synthetic oil
Adhesives:
• 5-minute epoxy
• thin CA
• medium CA
Warning
This RC aircraft is not a toy!
If misused, it can cause serius bodily harm and damage to property.
Fly only in open areas, preferably in official flying sites, following all
instructions included with your radio and motor.
This plane is a compromie between Aerobatics and 3D flying, and not a pylon
racer.
It is built with a very light structure and for this reason we hardly recommend:
→ Do NOT fly your airplane at high speeds, because this may cause structural
failures or flutter due to the extremely large control surfaces.
3
To Next Page
Loading...
