Before starting assembly
Before starting the assembly, remove each part from its bag and protection for a prior
inspection. Closely inspect the fuselage, wing panels, rudder, and stabilizer for
damage. If you find any damage or missing parts, contact the place of purchase.
If you find any wrinkles in the covering, use a heat gun or covering iron to remove
them. Use caution while working around areas where the covering material overlap to
prevent separating the covers.
Warranty information
SebArt garantees this kit to be free from defects in both material and workmanship at
the date of purchase.
This warranty does not cover any parts damage by use or modification, and in no case
shall SebArt’s liability exceed the original cost of the purchased kit.
Further, SebArt reserve the right to change or modify this warranty without notice. In
that SebArt has no control over the final assembly or material used for the final
assembly, no liability shall be assumed or accepted for any damage of the final user-
assembled product. By the act of using the product, the user accepts all resulting
liability.
If the buyer is not prepared to accept the liability associated with the use of this
product, the buyer is advised to return this kit immediately in new and unused
condition to the place of purchase.
RADIO SET UP
Control throws
We recommend the use of a computer radio, that will allow you to do quite a bit of
fine-tuning of the feel of the Sukhoi, which will make aerobatics even easier.
For the AILERON we recommend the following throws:
Low rate: 20° up / 20° down Expo: 40%
3D rate: 45° up / 45° down Expo: 80%
For the ELEVATOR we recommend the following throws:
Low rate: 20° up / 20° down Expo: 25%
3D rate: 60° up / 60° down Expo: 80%
4
To Next Page
Loading...
