For the RUDDER we recommend the following throws:
Low rate: 30° left / 30° right Expo: 30%
3D rate: 50° left / 50° right Expo: 60%
Note: the Expo is (+) for JR systems, and (–) for Futaba systems.
Mixing
For best performance, we recommend a linear-mix*: Rudder Elevator UP
When you give full rudder to the right or left side, the elevator have to go up
(positive) approx. 4%
* if you have a programmable computer radio.
Rates and expos
Use the recommended expos to soften the feel of the model, especially on high 3D
rates. The goal is to get the model to feel the same around neutral as it does on low
rates.
Use low rate settings for all flying, included starts and landings, and high rate for
3D aerobatics.
For precision flying or general sport fliers, the low rate throws are perfect, even for
snap rolls. When doing 3D aerobatics, flip to 3D rates just before the manover. As
soon as the manover is done, flip back down to low rate to avoid over-controlling the
model.
Recommended CG
The recommended Center of Gravity location is 150mm behind the
leading edge of the wing against the fuselage.
Use the motor battery pack, moving it forward or backward, to achieve the correct
balance.
Pre-flight
Never attempt to make full throttle dives!
This model have to be flown like a full-scale airplane. If the airframe goes too fast,
such as in a high throttle dive, it may fail.
Throttle management is absolutely necessary.
5
To Next Page
Loading...
