Sebo automatic X Series User Manual

T
o use the hose without the cleaning wand (as shown in figure 5), pull the hose out of
the cleaning wand while the tube is still attached to the machine and securely seated
over the protruding tab (31). Insert an attachment tool, if desired, onto the end of the
flexible hose. You may also release the hose while the cleaning wand is disengaged
from the machine by pressing the hose release button (32) at the base of the cleaning
wand handle (4).
While using attachment tools, if the power head brush roller is not able to disengage
f
rom the floor surface, the stationary-use warning light will flash. You may keep the
brush roller off the carpet by placing the handle (1) in its upright locked position and
lowering the handle with one hand to raise the brush roller off of the floor. Operate
attachment accessories with the other hand. Or, with the handle in the upright
locked position, the machine may be tipped backward so that it rests against furni-
ture or the floor on the back side of the bag housing (15), and the power head is
locked in a perpendicular position to the floor. Ensure that no children or pets can
come into contact with the spinning brush roller.
To vacuum walls, under beds, or higher-reach areas, etc., the SEBO AUTOMATIC X
can be fitted with an optional straight tube (33) and the optional wall and floor brush
(34). The machine will then perform as a canister vacuum (as shown in figure 7).
36
a
b
36
a
b
c
d
The Adjustment Wheel - Figures 10 & 11
On hard floors (figure 10), the adjustment wheel (36), moves upward into the machine
so that the brush lowers and becomes flush with the floor.
On carpeted floors (figure 11), the adjustment wheel (36) moves downward out of the
machine so that the brush rises. The adjustment wheel moves up and down automat-
ically to adjust the brush to the correct setting. This provides aggressive brush action,
while maintaining optimal air flow.
Hard Floor - Figure 10
Carpeted Floor - Figure 11
The Display Panel - Figure 8
Green light (a): Brush is lowering
Green light (b): Brush is rising
Red light (c): Flashing and motor off - brush jammed – clear jam
Red light (c): Flashing and motor on (when machine is in upright,
locked position) – Take care, brush in contact with carpet
Red light (c): Continuous – change brush roller
Red light (d): Continuous – change bag or clear clog
Red light (d): Flashing – motor switched off due to full bag or clog
For more information on the display panel, see pages 4 and 5.
Boost Function* (X7 Premium and X7 Premium Pet) - Figure 9
For high energy efficiency and deep cleaning of the carpet, the SEBO AUTOMATIC
X7 Premium and X7 Premium Pet vacuums are equipped with a boost button (35).
Press the button (35) by hand to activate the boost function. Once activated, the but-
ton will illuminate green. To deactivate the boost function, press the boost button
again.
NOTE: The boost function will be automatically deactivated when the machine is
turned off. After switching on the machine again, the boost function has to be acti-
vated separately.
* Depending on model
F
igure 7
Figure 8
33
34
9
35
Figure 9

Sebo automatic X Series Specifications

General

Brand	Sebo
Model	automatic X Series
Category	Vacuum Cleaner
Language	English