14 •
4.3 Verifying position of measuring rod
Checking position After mounting the measuring rod, you must check its
position and correct if necessary. To do so, proceed as
follows:
1. Use a spirit level to ensure that the measuring rod is
vertical.
Requirement: The measuring rod is inclined neither
towards nor away from the wall.
2. If the measuring rod is not vertical, correct its positi-
on as described in the section below.
Adjusting position To correct the position of the measuring rod proceed
as follows:
1. Loosen the screws of the measuring rod.
2. Correct the position of the measuring rod by adding
or removing spacer washers.
3. Tighten the screws on the measuring rod.
4. Check the position of the measuring rod again.
5. If necessary, re-adjust the position of the measuring
rod.
NOTE:
Your seca service partner will also be happy to
help. You can find your local seca service part-
ner at www.seca.com or just send an e-mail to
service@seca.com.
max = 5
min = 1
max = 5
min = 1
To Next Page
Loading...
Need help?
General
