16 •
7. Shorten the plastic screws so that they finish flush
with the spacer washer.
Fitting the heel stop
1. Undo the screws of the measuring rod.
2. Put the measuring rod in the grooves of the heel
stop.
3. Screw the measuring rod firmly to the wall again.
4. Check the position of the measuring rod as descri-
bed in Section “Verifying position of measuring rod”
from page 14.
NOTE
You can use the metal screws and standard
wall plugs supplied as an alternative mounting
option for the heel stop. This allows you to
screw the heel stop to the wall in the same way
as the measuring rod itself.
To Next Page
Loading...
Need help?
General
