18
– Undo the mounting for the display cable
on the handrail and connect it to the ca
-
ble for the display.
– Push the cable carefully into the hand-
rail and push the display onto the hand-
rail. Ensure that the positions of the
adhesive labels on the handrail and the
display match.
– Check that the holes on the bottom of
the display match the holes on the
handrail and then screw the display to
the handrail using the three screws.
Power supply
The scale is powered by a mains unit.
Please use only the mains unit sup-
plied or mains units from the seca
range of accessories. Before plugging
the unit into the socket, check whether
the mains voltage marked on the
mains unit matches local mains
voltage.
If your scale is equipped with seca mains power unit 68-32-10-263, please proceed as
follows:
– The mains power unit can be adapted
to a wide variety of socket systems us
-
ing the adapters. Change the adapter of
the mains power unit if required:
Pull the adapter off the mains power
unit from the side.
Then plug the correct adapter onto the
mains power unit. Ensure that the
adapter is properly engaged and se
-
curely located.
Display cable
To Next Page
Loading...
