To Next Page
S
Stephanie RobinsonAug 20, 2025
What to do if the display "StOP" appears on Seca 684?
- EerochaAug 20, 2025
The "StOP" message indicates that the maximum load has been exceeded. Remove some of the load from the scale.
What to do if the display "StOP" appears on Seca 684?
The "StOP" message indicates that the maximum load has been exceeded. Remove some of the load from the scale.
Why is no weight displayed when there is a load on my Seca 684 Scales?
This issue may occur if the scale is not switched on. Check that the scale is powered on.
What to do if the display "tEMP" appears on Seca Scales?
The "tEMP" message indicates that the ambient temperature is too high or too low for the scale to function correctly. Set up the scale in a room where the ambient temperature is between +10 °C and +40 °C. Then, wait approximately 15 minutes to allow the device to adjust to the ambient temperature.
What does "Er:X:11" mean on Seca 684 and how to fix it?
The error message "Er:X:11" indicates that the scale has too high a load or too much load in one corner. Remove some of the load or distribute the weight more evenly. Then, restart the scale.
What does "Er:X:12" mean on Seca Scales and how to resolve it?
The error message "Er:X:12" indicates that the scale was switched on with too high a load. Remove the load from the scale, and then restart the scale.
How to fix Seca 684 Scales when 0.00 does not appear before weighing?
If '0.00' does not appear before weighing, it might be because a load was already on the scale when it was switched on. Remove the load, then switch the scale off and back on again.
What does "Er:X:16" mean on Seca Scales and how to troubleshoot it?
The error message "Er:X:16" means that the scale was caused to oscillate, and the zero point could not be determined. Restart the scale.
Why do Seca 684 transmit measurement results and beep twice after the first switch on?
This happens when the scale can't send measurement results to the wireless receiver (like a Seca wireless printer or a PC with a Seca USB wireless adapter). Ensure the scale is integrated into the wireless network and that the receiver is switched on. Interference from HF equipment (like cell phones) nearby can also cause this. Keep such equipment at least 1 meter away from the scale and receiver.
What does "Er:X:71" mean on Seca 684 Scales and how to resolve it?
The error message "Er:X:71" indicates that data transmission is not possible because the wireless module is deactivated. Activate the wireless module.
What does "Er:X:72" mean on Seca 684 and how to resolve it?
The error message "Er:X:72" indicates that data transmission is not possible because no wireless group is set up. Set up a wireless group.
General| Graduation | 100 g |
|---|---|
| Display | LCD |
| Type | Digital Scale |
| Capacity | 300 kg |
| Functions | BMI calculation, Tare function |
| Power supply | power adapter |
| Data transmission | RS232 |
