24
17. Pass the connector cable for the
display downward, from the top right
through the right rear side post (8).
18. Place the covers (9) on the left and
right end of the transverse bar.
19. Initially fasten the covers on the two
outer holes using the M3.5 x 9.5
pan-head tapping screws.
20. Place the support and display (10)
onto the upper transverse bar. Next,
fit the bolts on the inner holes of the
covers.
21. Connect the connector cable to the
electronics box (11).
22. Screw-tighten the folding seat (12)
from the rear onto the left side piece
using the M6 x 20 oval head screws
and plain washers.
23. Place the appropriate covers on the
countersunk bolt heads.
8
10
9
11
12
9
To Next Page
Loading...
