Seccua UrSpring - 2.4.4 Select Time Format; 2.4.5 Set Correct Time; 2.4.6 Set Water Temperature; 2.4.7 Set Flush Length

2.4.4 Select the time format
1. Select the menu Change settings? > Time format.
2. Use and to select am/pm or 24h time format and confirm with .
2.4.5 Set the correct time
NOTICE Setting the time is important to make sure the flushing (Flushing the filter module)
happens at the prefered time.
1. Select the menu Change settings? > Set Time.
The display shows: Set hour.
2. Use and to select the correct current hour and confirm with .
T
h
e
d
i
s
p
l
a
y
s
h
o
w
s
Set min.
3. Use and to select the correct current minutes and confirm with .
2.4.6 Set the water temperature
The water temperature setting is not available in the UrSpring Home..
NOTICE The water temperature influences the lifetime of the filter. The controller uses this
setting to predict a precise lifetime.
1. Select the menu Change Settings? > Water Temp.
2. Use and to set the correct temperature and confirm with.
2.4.7 Set the flush length
The recommended flush lengths are:
● For city water 5 seconds (maximum 10 seconds)
● For well water 10 seconds (maximum 20 seconds)
● For hot water 5 seconds (maximum 10 seconds)
Note that if the cleaning has to be improved, it is not useful to increase the flush length to longer
than the maximum mentioned above. In that case it is better to flush more than once a day (see
Automatic flush when fouled).
.
The prefered length can be entered as follows:
1. Select the menu > “Chg. Flush mode?” > “Flush length”.
2. The display shows: x Seconds.
3. Use and to set the prefered duration and confirm with .
P
a
g
e
1
3
/
5
0