Seccua UrSpring - 2.6.1 Preparation for Replacement; 2.6.2 Remove Filter Module

2.6.1 Preparation
NOTICE Make sure spilled water can not cause any damage.
1. Close the water in feed and filtered water lines.
2. Depressurize the UrSpring with a manual flush (see Flushing the filter module).
3. Disconnect the power by removing the plug from the mains socket.
2.6.2 Remove filter module
1. Place a bucket or other water container under the filter module.
2. Remove the bottom clamps Ⓑ from the filter module.
3. Pull the end cap Ⓒ from the filter module. Be careful not to damage the end cap.
4. Let the water flow out of the filter module.
5. Remove the top clamps Ⓐ from the filter module.
6. Pull the filter module out of the control unit.
Page 16/50