Contents
1. Introduction 5
1.1 Intended use 5
1.2 Filtering principle 5
1.3 Overview of the UrSpring 6
1.4 About this manual 7
1.5 Warranty 8
2. Using the UrSpring 9
2.1 User interface 9
2.2 Using the menu 10
2.3 Viewing controller measurements 10
2.3.1 Flow 10
2.3.2 Pressure drop (p-drop) 10
2.3.3 Filter state 10
2.3.4 Filter life left 11
2.3.5 Current pressure difference 11
2.4 Configuring the controller 11
2.4.1 Enter the serial key (SK) 12
2.4.2 Select the the English language for the controller menu 12
2.4.3 Select metric or US units 12
2.4.4 Select the time format 13
2.4.5 Set the correct time 13
2.4.6 Set the water temperature 13
2.4.7 Set the flush length 13
2.4.8 Select to delay flush during water use 14
2.4.9 Flushing the filter module 14
Daily flush 14
Automatic flush when fouled 15
Manual flush 15
2.5 Reset the UrSpring to factory settings 15
2.6 Change a filter module 15
2.6.1 Preparation 16
2.6.2 Remove filter module 16
2.6.3 Place a new filter module 17
3. Installing the UrSpring 18
3.1 Before you start 18
3.1.1 Safety for installation 18
3.1.2 Check the requirements 18
Page 3/50
To Next Page
Loading...