Securam ProLogic L02 User Manual

SecuRam Systems Inc. USA Page 1
Important:
● For indoor use only.
● Use one 9V alkaline battery. Always use an alkaline battery for high quality
performance, otherwise controller might not work well.
● Low Battery Alert: The display will alert low battery when battery voltage
reaches 5.4±0.2V. PLEASE REPLACE THE BATTERY IMMEDIATELY.
● When the display alerts low battery, Digital Entry Pad can only be operated
to lock or unlock. Operations, such as enrolling, deleting or time-delay
setting, are not permitted.
Battery Replacement Instructions
1) In the back of Entry Pad you will see one 9 V alkaline battery. Take the
battery out of the battery compartment.
2) Gently remove the connector by unsnapping it from the two terminals on
the top of the battery.
Never Pull on the Battery Leads.
3) Connect a new 9 V battery to the battery clip.
4) Put the battery and the leads completely back into the battery
compartment.
For mounting and wiring information refer to the installation instruction
in this manual.
Document No.: 2U-EC0601AL02130919
Version No.: V1.01 USER
ProLogic L02 Operating Instructions
 30 Codes; 2 Manager Codes, 28 Users
 Super Code
 Time Delay 0-99 minutes; Time Window 1-15min;
 Manager codes are TDO and Dual Overide Codes
 System Recovery
 Enable/Disable User Codes
 Can control up to 4 locks
 Penalty Time after 4 incorrect code entries = 5 min
 Can be paired with any SecuRam lock body

Securam ProLogic L02 Specifications

Power

power supply	one standard 9V Alkaline battery
static current	50μA
battery low voltage	5.4±0.2V

Battery

battery life span	About 1 year

System

registration capacity	30 codes
code length	6 digits
working humidity (max)	90%

Summary

Battery Replacement and Important Notes

Battery Replacement Instructions

Step-by-step guide for safely removing and replacing the 9V battery.

Code Management

Change Manager Code

Procedure to change the default Manager Code (ID01).

Enroll Manager and User Codes

Steps to enroll the second Manager Code (ID02) and additional user codes (ID03-30).

Change User Codes

How to modify an existing user's code.

Disable and Enable User Codes

Temporarily disable or re-enable user access to the system.

Lock Operation and Security Features

Wrong Entry Penalty

System response to incorrect code entries and penalty time activation.

Set Number of Locks

Configure the system to control up to four locks using a junction module.

Authorize Access to Locks

Grant specific user access rights to individual locks.

Time Delay and Unlocking Procedures

Set Time Delay and Time Window

Configure lock delay times and the period for valid code re-entry.

Time Delay Override (TDO) Setup

Assign TDO capability to specific user IDs for bypassing time delays.

Unlocking with Time Delay

Process for unlocking the lock when time delays are active.

System Administration and Maintenance

Delete Users

Procedures for deleting single users or all users from the system.

Dual Mode and System Information

Enable Dual Mode and view system status like firmware and user capacity.

System Recovery and Reset

Methods for recovering the system using recovery codes and reset procedures.

Simple Mechanical Reset

Procedure to reset the lock to factory default analog mode.

Specifications