HF Series Generators -- RAD Console
Operation
OM- 0279R1
9
2.7 ELECTROMAGNETIC COMPATIBILITY (EMC)
This equipment generates, uses, and can radiate radio frequency energy. The
equipment may cause radio frequency interference to other medical or non
medical devices and radio communications. To provide reasonable protection
against such interference, this product complies with emissions limits for a
Group 1, class A Medical Devices Directive as stated in EN 60601--1--2.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment is found to cause interference (which may be determined by
turning the equipment on and off), the operator (or qualified service personnel)
should attempt to c orrect the problem by one or more of the following measures:
• reorient or relocate the affected device,
• increase the separation between the equipment and the affected device,
• power the equipment from a source different from that of the affected
device,
• consult the service engineers for further suggestions.
To comply with the regulations on electromagnetic interference for a Class A
FCC Device, this equipment must be used in shielded areas and all
interconnect cables to peripheral devices must be shielded and properly
grounded. Use of cables not properly shielded and grounded may r esult in the
equipment causing radio frequency interference in violation of the FCC
regulations.
Before using this equipment make sure that all requirements
about EMC included in this manual are accomplished.
It is customer responsibility to assure that this equipment
and vicinity equipment complies the value of radio frequency
interferences shown in General Regulation for safety
according to IEC 60601- 1- 2 Tables as described in this
section.
To Next Page
Loading...