TA Operation/Maintenance Instructions Page 3 of 36
List of Contents
1.0 Design and Purpose
1.1 Illustration
1.2 Machine Specification
1.3 Shipping Details
2.0 Handling Instructions
2.1 Positioning
2.2 Foundation Drawings
3.0 Connection to a Dust Extraction System
4.0 Electrical Installation
5.0 Switchgear
5.1 The Padlockable Isolator
5.2 Start/Stop Buttons
5.3 Circuit Protection
5.4 Emergency Foot Operated Stop Switch
6.0 Machine Setting
6.1 The Spindle Rise & Fall
6.2 Tilting The Spindle
6.3 The Rip Fence
6.4 The Rip Fence Fine Adjuster
6.5 The Riving Knife or Splitter
6.7 Pushsticks
6.8 The Rear Extension Table
6.9 Blade Changing
7.0 Blade Selection
7.1 Blade Maintenance
8.0 Limitations of Use and Safe & Working Practices
8.1 Noise Reduction
8.2 Warning Labels
9.0 Maintenance
9.1 Cleaning & Lubrication
9.2 620mm Cross Cut Table Setting & Installation
9.3 1220mm Panel Sizing Table Setting & Installation
9.4 Riving Knife Maintenance
9.5 Saw Spindle Maintenance
9.6 Belt Tensioning
9.7 Pulley Alignment
9.8 Rip Fence Alignment
9.9 Electro-magnetic Brake Installation & Maintenance
10.0 Electrical Information
10.1 Electric Motors: Trouble Shooting Checklist
10.2 Wiring Diagrams
11.0 Parts List
To Next Page
Loading...