Have Questions?
If you encounter any problem, please refer to the following websites for resources & help.
For all the Grove resources for LaunchPad
www.seeed.cc/s/boosterpack
For the details of Grove system
http://www.seeedstudio.com/wiki/GROVE_System
For tech support for your Grove Base BoosterPack or Starter Kit
http://support.seeedstudio.com
For all the details and support of TI LaunchPad development kits
http://www.ti.com/launchpad
For all details around the Energia software
http://www.energia.nu
For community support, check out http://www.43oh.com
NOTE
This kit is fully compatible with the BoosterPack pin out standard, which is documented here:
http://www.ti.com/byob
Most of the LaunchPad development kits from Texas Instruments adhere to this pinout standard
enabling support for the Grove Base BoosterPack. The following examples were developed for
the MSP-EXP430F5529LP LaunchPad, which features a 40 pin BoosterPack connector.
However any 40 pin LaunchPad with Energia support can leverage these tutorials as well. If you
are using a 20 pin LaunchPad (i.e. MSP-EXP430G2), jumpers can be used to route the
appropriate pins to the various Grove connectors on the Grove Base BoosterPack.
To ensure compatibility, we recommend that you check the BoosterPack and software pin
configurations for your specific LaunchPad kit.
If you are using different LaunchPads, please refer to http://energia.nu/ for additional information.
You can find the various pin mapping diagrams at: http://energia.nu/guide/pinmapping/
To Next Page
Loading...
Need help?
General
