90
• Using your fingers, turn the Ring counter clockwise 5
degrees until the tabs engage, then tighten it 5 more de-
grees by turning it counter clockwise with the aide of a
small blade screwdriver, pressing against the upper/left
arm of the Ring (Fig. 90).
NOTE: If available, an adjustable face spanner
tool or pair of pointed pliers can be used by
placing the tips in the small holes of the Ring
(Fig. 91).
Inspection
• Activate the unit and watch carefully as it performs a full
diagnostic and battery check, and enters Surface Mode.
Observe the LCD display to ensure it is consistently
clear and sharp in contrast throughout the screen.
WARNING: If any portions of the display are
missing or appear dim, or a Low Battery con-
dition is indicated, return your XP 5 to an Au-
thorized XP 5 Dealer for a complete evaluation
before attempting to use it.
Fig. 90 -Ring Installation
Fig. 91 -Ring Installation
(alternate)
To Next Page
Loading...
