31
ENTERING SETTINGS -SET MODE #2
NOTE: To return to Surface Mode at any time
while in Set Mode, press and hold Both
buttons for 2 seconds. The unit will
automatically revert to Surface Mode after 2
minutes if no button is pressed.
TO SET - UNITS OF MEASURE
(while in the Surface Mode)
Factory set for Imperial, Units of Measure can also be set
for Metric.
• Press Both buttons, release when SET: 2 appears.
• Press and release the Advance (Front) button, the Units
screen appears with the graphics F (or M), and the
Temperature icon and letter F (or C) appear with flash-
ing (Fig. 25).
• Press the Select (Side) button to toggle between
Imperial (F ) and Metric (M and C) units.
• Press the Advance (Front) button to accept the setting
and advance to Set Hour Format, or press and hold Both
buttons for 2 seconds to revert to Surface Mode.
Fig. 25 - Set Units of Measure
To Next Page
Loading...
