To Next Page

To Previous Page

Technical Manual WIC1 SEG Electronics GmbH

DOK-TD-WIC1E, Rev. M 43

6. Commissioning and Maintenance

6.1.1 Important note

Putting into operation and the relevant tests should only be carried out by skilled personnel.

We do not accept any liability for damage caused by improper handling of the protection

system, or of the primary side of the equipment. Pay attention to check that over the prima-

ry circuit no second current flow way is possible. (Grounding of the feeder).

6.2 Accessories for commissioning work

For commissioning of the protection system the following accessories should be available:

 For WIC1-1 and WIC1-4: an adapter WIC1PC3, and a PC with software

 Secondary testing system (see chapter 6.3ff)

 Screwdriver; cross slot type, size 1; 3mm slot

 Setting parameters

Questions and Answers:

Need help?

Do you have a question about the Seg WIC1-W3 and is the answer not in the manual?

Seg WIC1-W3 Specifications

General