60www.seuservice.com
Before starting to work, ensure that the Power SW is OFF. Failure to observe
this can cause electric shock or short circuit.
Use care so as not to damage wirings. Damaged wiring can cause electric
shock or short circuit.
Do not touch undesignated places. Touching places not designated can cause
electric shock or short circuit.
This work should be performed by the Location's Maintenance Man or
Serviceman. Performing work by non-technical personnel can cause electric
shock hazard.
When performing work such as parts replacement other than those specified
in this manual, be sure to contact where you purchased the product from.
Confirm the work procedures and obtain precautions from where you
purchased the product prior to performing work. Inappropriate parts
replacement and/or installation with erroneous adjustment can cause an
overload or the parts to come into contact, resulting in an electric shock, a
short circuit, and a fire.
12. PADDLE (WING) SHIFT
In case the Paddle Shift operability is poor, malfunctioning of or a damage to the Microswitch
inside the Paddle Shift can be considered.
Turn off power.
Take out 4 Truss screws for each to remove Boss Cover Upper and Lower.
Disconnect the wiring connected to the Microswitch.
BOSS COVER
TRUSS SCREW (4 each)
M4 X 8
PHOTO 12 a
SWITCH REPLACEMENT
3
1
2
To Next Page
Loading...
