EasyManua.ls Logo

Sega NAOMI - Backup Data Clear Function

Sega NAOMI
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1
1. HANDLING PRECAUTIONS
To prevent electric shock or IC Board malfunctioning, be sure to turn off the
power for the cabinet when installing or removing the IC Board.
Extraneous matter such as dust on the IC Board can cause the IC Board to
generate heat and result in a fire due to short circuit, etc. Ensure the IC Board
surfaces are always kept clean.
Keep the IC board well cooled.
The NAOMI board case and GD-ROM drive are provided with ventilating
fans. Do not block the air outlets of these fans. Also do not place anything
closely to the NAOMI board case and GD-ROM drive. Failure to observe
these instructions may cause an overheating and fire.
Be sure to connect the IC Board and connectors completely . Insufficient
insertion can damage IC Board, etc.
For the IC Board circuit inspection, only the use of Logic Tester is permitted.
The use of ordinary testers is not permitted as these can damage the IC Board.
Do not subject the IC Board to static electricity when installing the IC Board
in the cabinet or when connecting wire harness connectors to the IC Board.
When soldering buttons, etc. to the wire harnesses, be sure to remove the wire
harnesses from the IC Board so as not to subject the IC Board to heat.
Using NAOMI without the Shield Case can cause electric wave trouble. Be
sure to use NAOMI together with the accessory Shield Case.
The monitor frequency corresponding to NAOMI is 15kHz or 31kHz.
NAOMI can not be used for the cabinet incorporating a monitor or projector
not corresponding to 15kHz or 31kHz.
Use the NAOMI board with the JVS-compatible cabinet. Using it with the
non-JVS-compatible cabinet may cause an overheating and fire.
Concerning the display of JAMMA VIDEO STANDARD:
JAMMA VIDEO STANDARD adopted by NAOMI is referred to as JVS. As against this
Standard, the conventional JAMMA STANDARD which employs 56P Edge Connectors
adopted by ST-V, etc. is displayed as Old JAMMA STANDARD.
The specific Manual attached to each game sometimes displays JVS as JV STANDARD, New
JAMMA STANDARD, or JAMMA 2 STANDARD AGAINST OLD JAMMA STANDARD as
JAMMA STANDARD, JS, etc.
The contents herein described are subject to change without notice.
STOP
IMPORTANT

Other manuals for Sega NAOMI

Related product manuals