Segway InfoKey - Connecting an InfoKey to the Programming Fixture

8 Setting Up the Programming Fixture
1
Place the InfoKey, screen side up, over the center of the
programming xture. Align the yguy logo on the InfoKey
with the white dot on the programming xture.
2
Rotate the InfoKey clockwise until the two yguy logos
align. You should feel a click as the InfoKey locks into place.
3
Placing your ngers on the InfoKey’s outer plastic housing,
press straight down until it locks into place. The white ring
around the top of the programming xture will light when
the InfoKey is properly connected.
NOTE: To avoid damaging
the InfoKey, do not press
down on the screen when
installing it into the
programming xture.
You are now ready to use the InfoKey Programming Tool to
create, duplicate, or change the InfoKey conguration. See
the
Programming an InfoKey procedure (p. 10) for more
information.
Connecting an InfoKey to the Programming Fixture
Complete the following steps to connect an InfoKey to the programming xture.