Segway InfoKey - Changing an InfoKey

16 Programming an InfoKey
Changing an InfoKey
Use the CHANGE function and complete the following steps to change the conguration of an InfoKey.
1
Start the InfoKey Programming Tool and log in.
The system displays the
Take the InfoKey to be modied
and place it in the xture
window.
2
Insert the InfoKey to be modied into the programming
xture and click CONTINUE.
3
From the Main Menu click CHANGE. The system displays
the
Reading InfoKey Conguration window.
3
(Continued)
When the reading is complete, the system displays the
current InfoKey conguration.
Note: The units of measure display (MPH or KM/H) on the
Change
screen is determined by the regional settings on your PC. Refer to the
FAQ section for more information.
4
Change the InfoKey conguration settings as follows:
Top Speed (MPH): Click in this eld and enter a top speed
for Standard Setting speed limit. If the value is outside the
available range, the system displays a message with the
range of possible values (4.0 to 12.5 MPH).