How to install ultrasonic sensor
Installation guidance:
1. Power off the mower. 2. Take off the cover.
3. Connect the communication plug. 4. Use the Allen wrench to tighten the two screws.
3.10 VisionFence Sensor (optional)
VisionFence Sensor can significantly improve Navimow's obstacle recognition and avoidance capability. It is sold separately and
can be installed on all Navimow models. Consult your dealer for further information.
The VisionFence Sensor is designed to achieve accurate obstacle avoidance by identifying and calculating grass and non-grass
objects. When the signal is weak, the mower will start avoiding obstacles through visual recognition. Thanks to the advanced visual
recognition algorithm, the sensor can identify obstacles and start avoiding obstacles when the mower is about 0.3 m (11.8 in) away
from them. With the VisionFence Sensor, the mower can avoid some obstacles, such as trees and flowerpots, without setting them
as off-limit islands. However, there is a certain probability that the VisionFence Sensor will fail to recognize obstacles that are too
small (less than 10 cm(3.9 in) in length and width), too thin, tilted, dangling, or easily confused with lawn. For example wire fences,
moss, ornamental grass, bushes, dirt, roots, leaves, etc.
With the VisionFence Sensor installed, the mower is more adaptable to complex yards. When the satellite signal is weak in areas
with challenging layouts, the VisionFence Sensor can identify the lawn's edge and allow the mower to keep mowing the lawn.
Separate from the mower, the VisionFence Sensor has its own Wi-Fi module to connect to the internet. The VisionFence Sensor can
function normally without network, but it must be connected to a Wi-Fi network when the firmware needs to be updated.
44
To Next Page
Loading...
