How to install VisionFence Sensor
How to change the VisionFence Sensor setting
You can go to Settings >MOWER>VisionFence Sensor to turn on/off the sensor, check the sensor firmware version and configure
the sensor network setting.
≥4s
MOWER APP
XXXXXX XXX
XXXXXX XXX
XXXXXX XXX
XXXXX
XXXXXX XXX
XXXXXX XXX
XXXXX
XXXXXX XXX
XXXXX
XXXXXX XXX
XX
XXXXXX XXX
XXXXXX XXX
4. Place the rubber stoppers and bumps
against the surface of the mower.
3. Connect the plug.
1. Power off the mower. 2. Take off the cover.
5. Tighten the screws. 6. Install the decorative cover.
7. Power on the mower. 8. Tap VisionFence Sensor in the Navimow
app to configure the network.
NOTES:
1. VisionFence Sensor may not work well in low-light situations, resulting in limited obstacle avoidance performance in some complex yards.
2. Clean the lens of VisionFence Sensor by spraying water regularly, avoiding the lens being obscured by stains or mud.
3. For the best obstacle avoidance effect, we recommend that obstacles larger than 1 m and smaller than (0.1 m(3.9 in) in diameter
should be set as off-limit islands.
4. To update VisionFence's firmware, please connect it to a Wi-Fi first. Make sure the charging station is also in the coverage of a 2.4
GHz Wi-Fi network.
45
To Next Page
Loading...
