MAINTENANCE, STORAGE AND TRANSPORTATION
121
Front/Rear Axle Gear Oil
1
Filling plug
2
O-ring
3
Drain plug
1. Put the vehicle on the flat level surface
2. Place an oil drain pan under the drain plug
3
3. Remove the drain plug
3
and O-ring
2
；
Torque to specification
：
Torque
Drain Plug: 11.8-14.8ft·lb. (16~20N.m )
4. After the oil has completely drained, reinstall the drain plug
3
and a new O-ring
2
.
The oil discharged is harmful to the environment. Properly dispose
of the oil properly
.
5.
Remove the Filling plug
1
and O-ring
2
，
Add the
recommended liquid as needed to make the liquid level reach
the bottom of the filling hole thread.
To Next Page
Loading...
